535006796 381509312 535017577 590259883 259.883 Charmilles DC motor ​

535017577 590259883 259.883 Charmilles motor with cables m12

535006796 381509312  AgieCharmilles DC motor​

Folllowing codes for Charmilles EDM motors are all available

381507512    22SYK2209.A1200011P22A101
383505709   92SYX-200 

381511729     CUTE350
381507512     P22A1014-15000 CUT200
100542465    Charmilles Robfil 240
381506522    Agiecharmilles CA20 X Y axisABB

100432832
381509312​

Charmilles machines often use DC motors for precise spindle control, feed drives, and rotary axes. 

These motors provide smooth torque, easy speed control, and reliable performance for EDM and milling applications.

Key Features
Precise speed/torque control via DC drives or servo controllers.
Good low-speed torque for stable machining and positioning.
Compact design suitable for spindles, indexers, and auxiliary drives.
Compatibility with feedback devices (encoders/tachometers) for closed-loop control.

Common Applications
Spindle drives on small/high-precision machines.
Rotary tables and indexing heads.
Feed motors for axis motion where fine control is required.

Typical Problems & Symptoms
Excessive brush wear or arcing (in brushed DC motors).
Overheating, reduced torque, or speed instability.
Encoder or commutation faults causing position errors.
Electrical noise affecting control electronics.

Maintenance and Best Practices
Follow OEM service intervals​

inspect brushes, commutators, and bearings.

Keep cooling vents clean and ensure proper ventilation.
Verify motor wiring, grounding, and controller settings.
Replace brushes as matched sets and seat new brushes per manual.
Monitor temperature and vibration; use infrared checks for hotspots.

Troubleshooting Steps
Visual inspection of brushes, commutator, connectors.
Measure supply voltage, ripple, and controller outputs.
Check feedback device signals and continuity.
Swap suspected components (drive, motor) where possible to isolate faults.

Sourcing & Replacement
Use GF/Charmilles OEM motors or verified equivalents; supply machine model/serial when ordering.
Verify specs: nominal voltage, torque, shaft dimensions, encoder type, and mounting.
​